|
BROWSE BY PRODUCTS
Controllers
Transmitters
Recorders
pH Electrodes
ORP Electrodes
Chemical Metering
Pumps
Hand-Held meters
pH/ORP
Accessories
Chart Paper
Benchtop Meters
Chlorine Sensors
BROWSE BY MANUFACTURES
Pathfinder
Blue/white
Jenco
Fuji
IQ Scientic Instruments
Signet
Sensorex
Partlow
Pulsafeeder
Newport
Texmate
Rustrack
| |
JENCO /
CONTROLLER - 3671N
1/8 DIN panel mount pH/ORP controller with
dual SPDT Hi/Lo relays, manual set points and
calibration are via potentiometers. Features a
voltage/recorder output and an internal pH/ORP
select switch. Display is a large bright red
LED. Connectors are a BNC input and spade lug
screw type connector block. Meter requires a
Pt-100 ATC or a simulation resistor for
temperature. Power115/230A AC.
|
$ 225.00
 Download
Spec Sheet
|
FEATURES
All Solid State Design
- Low Cost - Easy To Install - Set Points On Front Panel - Recorder Output
- 0.56 High Efficiency Red LED
Display
- 1/8 DIN Aluminum Case - Set Points Cover Entire Span
- ATC For pH 0 To 100 °C - Internal pH/Orp Select Switch - Low Power Consumption Design,
Reduced Internal Heating Thus Increased
Reliability
|
|
electrode / accessory
options |
| JENCO
1922557-020HTV12 |
Industrial
Flat tip, Epoxy Body, 3/4 inch MNPT, Inline double junction
pH/Reference/Temperature probe with BNC connector ana a Pt-100 RTD for ATC
sensor with 3mm Phono Plug and 20 foot long cable.
Range 0 pH to 12 pH |
$179.00 |
| JENCO
1923737-020BGV12 |
Industrial
Spherical Tip with Protective Guard, Epoxy Body, 3/4 inch MNPT, Inline
Double Junction pH/Reference/Temperature probe with BNC connector and a
Pt-100 RTD for ATC sensor with 3mm Phono Plug and 20 foot long cable.
Range 0 pH to 12 pH |
$179.00 |
Primary Specs
| |
Range |
Resolution |
Accuracy |
|
pH |
0~14.0 |
0.1 |
0.1 ± 1digit |
| Orp |
-1990~1990 mV |
10 |
± 0.1% ± 1 digit |
|
Temp |
0 ~ 100 °C |
1 |
1 ± 1 digit |
GENERAL
|
Input impedance |
Greater than 10^12
Ohm |
|
Temp. compensation |
Auto 0 to 100 °C
|
|
Recorder output (pH) |
1400mV
|
|
Recorder output (mV) |
-1990 to 1990mV |
|
Recorder output
(Temp.) |
1000mV
|
|
Dual point On/Off
control |
pH or ORP with
internal select switch |
|
Dead band |
± 0.1 pH for each
set point |
|
Relay output |
8 A at 115VAC,4A at
230VAC |
|
Readout |
0.56 high efficiency
red LED display
|
|
Power source |
115 VAC/230VAC ¡À
15%,50/60Hz |
|
Dimension |
96mm x48mm x 172mm
|
|
Weight |
0.69 kg
|
|
