SENSOREX / Insertion Mounted pH

Known as Wet Tap, Insertion Assembly or Hot-tap, these sensors may be side mounted into tanks for installed in large diameter pressurized pipes. Use of a full port 1" ball valve allows removal without system shutdown.

PDF Spec Sheet

PART #	PRICE	DESCRIPTION	DESIGN
S655CD-PH	$127.00	Combination Electrode	Flat Surface Cartridge Style
S655CD-ORP	$149.00	Combination Electrode	Flat surface cartridge
S675	$221.00	Insertion assembly	12" Insertion Depth- Standard Unit
S676	$278.00	Insertion Assembly	18" Insertion Depth - Special Depth
S677	$295.00	Insertion Assembly	24" insertion Depth - Special Depth
S675TC#-L-EC-EC*	$310.00+1.95/FT.	Insertion Assembly	For General use
S648-L-EC*	$ 35.00 +.75/FT	Cable Assembly	Temperature Compensated
S653-L-EC*	$ 45.00 +.75/FT	Cable Assembly	For Conduit installation
bv-1	$ 49.00	1" Full Port Ball Valve	CPVC

* For cable Assemblies, please specify the "L" in feet and the "EC" = End Connections to match with your controller, ...ie = BNC + Bare Wire

PRODUCT FEATURES

Flat Surface /Self Cleaning Design
Hot-Tap Design /Use on Tanks or large diameter pipes
Cartridge Electrode /Easy and Fast to replace
Invertible Design /May be used
up-side-down
Insertion Style /No Need to Drain Tanks or De-pressurize lines

Because of it's cost effective CPVC construction, the Sensorex Insertion Assembly allows pH measurements to be made in pressurized tanks and main lines without having to use expensive stainless steel components.

The insertion depth is easily adjustable by the user, to be positioned in an turbulent area of the tank or line. This will optimize the self cleaning feature of the flat surface electrode. In abrasive applications, the electrode is usually positioned close to the pipe wall. This assembly is well suited for measurements in liquids with high suspended solids and for measurements in viscous liquids.

The insertion assembly can be fully retracted through an optional 1" full port ball valve, (Sensorex part number BV-1). The ball valve is then closed, isolating the electrode and holder from the pressurized system. This is accomplished without draining the tank, or de-pressurizing the line.

The special electrode used in the Insertion Assembly allows it to be mounted in any position; for example, even through the bottom of a tank with its measuring surface facing upward. The vast majority of pH electrodes in the world should be installed above the horizontal plane, due to the intentional placement of an air bubble in the pH stem (The air bubble compensated for pressure changes due to thermal expansion and contraction)

2075 CORTE DEL NOGAL, SUITE X

CARLSBAD, CA 92011

email: info@phorp.com