Mounting Location

• Choose an area located near the chemical supply tank, chemical injection point and electrical supply. Install the pump where it can be easily serviced.

• Mount the pump to a secure surface or wall. Wall mount to a solid surface only. Mounting to drywall with anchors is not recommended.

• Do not mount the pump directly over your chemical container. Chemical fumes may damage the unit. Mount the pump off to the side or at a lower level than the chemical container opening.

• Mounting the pump lower than the chemical container will gravity feed the chemical into the pump. This "flooded suction" installation can reduce the time required to prime the pump. Install a shut-off valve, pinch clamp or other means to halt the gravity feed to the pump during servicing.

• Your solution tank should be sturdy. Keep the tank covered to reduce fumes.

• Be sure your installation does not constitute a cross connection with the drinking water supply. Check your local plumbing codes.

Note: All diagrams are strictly for guideline purposes only. Always consult an expert before installing the Chem-Feed pump on specialized systems. The Chem-Feed should be serviced by qualified persons only.