WATER QUALITY TRANSMITTERS

The Model CT-1000-pt (encapsulated miniature transmitter) is a 2-wire, 4-20 mA conductivity transmitter featuring encapsulated construction, high performance and small size.

The unit uses an in-line/submersion conductivity cell Model CS650HTTC, CS675HTTC,CS676HTTC(range dependant), it utilizes a 1000 ohm platinum temperature sensor and can be used wit the afore mentioned electrodes in high temperature and /or high pressure applications It transforms the cell signal to a 4 to 20mA current proportional to the conductivity level. This output may be transmitted over two wires to a control location, the same 2 wires provide power to the transmitter. Any D.C. power supply from 12 to 36V may be used. There are two adjustments on the transmitter to standardize probes for "SPAN" and "ZERO". The output can be monitored with a loop powered meter, a loop resistor or a multimeter during the standardization procedure.

$219.00 Spec Sheet

Specifications

Available ranges: 0-10 mS to 5000uS

Output: 4-20mAPower

Supply: 12 to 36VDC

Load Resistor: 0 to 750W at 24VDC

Linearity: ±.2% of span

Temperature Compensation range...............................................0 to 100ºC

Operating Temperature Range: -25 to +70ºC

Reverse Polarity Protection: Internal diode

Dimensions: 1.5" × 2.0" × 1.0"

pHORP

4751 OCEANSIDE BLVD. SUITE D

OCEANSIDE, CA 92056

email: info@phorp.com