A division of Pathfinder Instruments, LLC     800-284-9698 

 

         pH  &  ORP  WATER  QUALITY  INSTRUMENTATION  SPECIALIST                                                                                   www.phorp.com

HOME TECHNICAL ARTICLES HOW TO ORDER ABOUT US CONTACT US WEBSITE LINKS

 

 

 

 

 

 

BROWSE BY PRODUCTS

 

Controllers                             

Transmitters

Recorders

pH Electrodes

ORP Electrodes

Chemical Metering

Pumps

Hand-Held meters

pH/ORP Accessories

Chart Paper

Benchtop Meters

Chlorine Sensors

 

 

 

BROWSE BY MANUFACTURES

 

Pathfinder

Blue/white

Jenco

Fuji

IQ Scientic Instruments

Signet

Sensorex

Partlow

Pulsafeeder

Newport

Texmate

Rustrack

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

                        

 

Pathfinder model SK-252  

MICROPROCESSOR - A computer on a chip of silicon with thousands of transistors and on-board memory, programmed to perform specific tasks as measurement and control with a high level of performance.

                  

 

 

 

 

 

 

                                                         KITS

 

SK252 pH CONTROLLER $27000   SK252 ORP CONTROLLER $270.00
SENSOREX              S650CD PROBE $121.00   SENSOREX               S660CD PROBE $144.00
S653 CAP/CABLE 10 FT. $  49.00   S653 CAP/CABLE 10FT $ 49.00

MANUAL                                     

The Model , SK252 is a microprocessor programmable controller that accepts any combination pH or ORP electrode as an input. Outputs are; one on-off or PID (with FUZZY LOGIC) proportional control relay; this output can be an SSR drive pulse, 3A mechanical contacts or a 4-20mA control signal, The output can be programmed to operate above or below the set point; the 4 to 20 mA output can be used as a proportional pump control signal or a recorder signal proportional to the pH or ORP level (0 to 100% of full scale or any portion there of. Optional programmable alarms can be added to alarm high, low, zone, with absolute or deviation set points. Optional RS 485(Modbus Protocol) output monitors up to 31controllers and comes with free windows based software Optional digital input for remote set point, timer or auto-tune control. The power source is from100 to 240 VAC, 50/ 60Hz free voltage there is no need to change connections for different voltages. The controller is programmable from the front panel via 3 switches, and calibration is done using two front panel adjustment pots. The front panel is a 1/16 DIN, NEMA 4X rated and mounting hardware is provided

SPECIFICATIONS:

Inputs...................................... pH or ORP combination electrode

Control outputs..........................( 1 ) 3A SPDT relay, or voltage pulse SSR, or 4-20mA

Alarm outputs (option)...............(up to 2) 1A SPST relay

Recorder output.........................4 to 20mA non-isolated( in place of a control output)

Front panel..................................NEMA-4X rated

Enclosure..................................1/16DIN panel mount (48x 48 x 95.8mm)

Power.......................................100 to 240vac 50/60 Hz

Programmable timer...................0 to 99h59m

Indicating Accuracy.......... ....... + 0.5% of Fullscale + 1 digit

Sampling Time......................... ..5 Seconds

Indication pH........................... 00.00 to 14.00 pH

Range ORP............................. -1000 to +1000 mv

ATC..........................................1000 ohm pt sensor ( for pH)

 

 

                                                            

©2006, pHORP

A DIVISION OF PATHFINDER INSTRUMENTS - ALL RIGHTS RESERVED   

2075 CORTE DEL NOGAL, SUITE X

CARLSBAD, CA 92011

email: info@phorp.com